System Recovery Doesn’t Work Properly with my branded PC/ Laptop. Did you experienced this problem?. When you try to restore you system in default setting by using System Recovery feature stored in your drive or System Recovery Disk, stop in the middle of setting up or in other way, after recovered procedure from default system the performance of your PC is not the same as before.

Possible Solutions:

• Check your CD Recovery if their is some scratches or damaged. In some cases, the installation procedure stop in the middle of setting up because some parts of data was damaged and can’t provide the full data required. The same also to the System Recovery featured stored on your drive.
• Replace your Optical Drive – If you’re optical drive not reading well, the same problem above is the possible caused.
• Replace your Memory Card (SDRAM,DDR,DDR2, DDR3). Possible that your memory is near to damaged.
• Scan your hard drive using scandisk repair procedure on DOS command. Possible that your hard drives contained bad clusters. To do this job, click start>run, under the run menu type “ CMD” to direct to DOS command and type “ Scandisk/r” and your PC/Laptop will ask for restart and when your PC load again, the scan procedure will automatically begin to check your drive.
• Lastly  and best solution for that problem. Slave you hard drive to other unit and delete all partition even the recovery system is included in the hardware. Why? because most of the drive partition was already damaged specially to the old computers/Laptop or long run of used and the only solution for that is to delete the partition and make a new one and setup again using Recovery Disk CD. But for those who didn’t  make backup Recovery Disk and they only using System Recovery stored on the drive, you can also use other operating System CD (Windows XP, VISTA, Windows 7 etc) the same with your OS and input the product key on your PC beside for CPU and at the back/under for laptop. So, your laptop/branded desktop still using license product key.